To fit
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
Fit in reverse order.
NOTE:
Work is facilitated if heavy pop-riveting pliers are used. Adjust the position of the window glass as follows:
- Raise the window to approximately 3 cm from the closed position.
- Press the window glass rearwards in the frame.
- Check that the top edge of the window is parallel with the frame.
IMPORTANT:
Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged.