To remove
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the window.
- Remove the door trim. See ADJUSTMENT - REPLACEMENT in INTERIOR EQUIPMENT.
- Remove the external window seal, it is fastened with clips at the rear.
- Remove the plastic water deflector.
- Remove the internal window seal by prying up the rear of the seal with a large flat screwdriver and pull up the seal by hand.
- Loosen the lower edge of the rear guide channel (still hanging from the window seal).
- Raise the window so that the window retainer is accessible through the lower opening on the inside of the door.
- Detach the scissor-lift stay from the window mounting by removing the clips and then prying the stay loose with a large flat chisel. Pry the top edge between the stay and the rail.
Pry close to the ball to avoid deforming the rail .
- Lift out the window by tilting up the rear edge.