LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Glass, Windows And Mirrors) >> Adjustment - Replacement >> Adjusting the front side window interior moulding, 3D, CV >> Adjustment

Adjusting the front side window interior moulding, 3D, CV: Adjustment

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push down the moulding to the correction position. Remove the door panel.
  2. Lower the side window.
    IMPORTANT: Protect the side window when drilling by placing a putty knife or similar tool between the interior side window moulding and the side window.
  3. Drill a 2 mm hole about 10 mm (3D) or about 55 mm (CV) from the rear of the interior window moulding.

    Drill through the moulding and the metal flange.

    4. Fig 1: Drilling 2 mm hole 10 mm (3D) or 55 mm (CV) From Rear Of Interior Window Moulding
    G03509455Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Screw on the moulding.
  5. Fit the door trim. See ADJUSTMENT - REPLACEMENT in INTERIOR EQUIPMENT.
scientia non olet · About LEMON Manuals