Unlocking all the doors with the remote control
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
Unlocking of the doors is accomplished by pressing button B.
When the button on the remote control is pressed, it sends a signal that is received by a receiver. The receiver processes the signal and transfers it to the TWICE control module.
A short voltage impulse is fed from the TWICE control module pins:
- Pin 26, driver's door (5D, 3D and convertible)
- Pin 69, front passenger door (5D, 3D and convertible)
- Pin 49, rear doors (5D)
The lock motors are grounded in the TWICE control module on
- Pin 42 and 22, driver's door (5D, 3D and convertible)
- Pin 66 and 22, front passenger door (5D, 3D and convertible)
- Pin 20 and 22, rear doors (5D)