LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Doors & Locks) >> Adjustment - Replacement >> Door lock, front door >> To fit

To fit

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit the door lock with the internal lock assembly and central locking system motor.
  2. Plug in the connector for the central locking system motor.
    Fig 1: Illustration For Step 2-6
    G03509251Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Fit the lower section of the rear guide channel.
  4. Press the pull rod onto the lock cylinder.
  5. Press the pull rod onto the interior handle.
  6. Check the door handle clearance against the lock. Adjust if needed, by adjusting up/down the opening rod adjusting screw until it is up against the lock opening lever.
    NOTE: It must be possible to feel the clearance in the door handle, the lock opening lever must not be actuated in the resting position.
  7. Fit the plastic water barrier.
    Fig 2: Illustration For Step 7
    G03509252Courtesy of SAAB-SCANIA OF AMERICA, INC.
    IMPORTANT: Make sure the water drainage plastic is tight against the inner panel of the door and that it is not damaged.
  8. Fit the door trim, see DOOR TRIM, FRONT DOOR .
scientia non olet · About LEMON Manuals