Rattle from the covering of the soft top cover: Procedure

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

Fit felt tape, part no. 49 60 555.

Run the soft top so that the soft top cover is in its upright position.
Check where the covering hits against the soft top cover.

Fig 1: Inspecting Soft Top Cover Covering Points
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit a few pieces of felt tape on the edges of the covering where the covering hits against the soft top cover ribs.

Fig 2: Fitting Felt Tape On Covering Edges
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Check that the noise is gone.