LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Convertible) >> Fault Diagnosis, Symptom >> Noise from A-pillar >> Procedure 4

Procedure 4

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

Symptom:  Creaking noise

Cause :  Insufficient junction plate welds.

  1. Remove the scuff plate.
  2. Remove the carpet.
  3. Unplug the wiring harness.
  4. Check that the junction plate welds are whole. If necessary, perform the following procedure:
    Fig 1: Inspecting Junction Plate Welds
    G03509081Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Grind the surfaces requiring welding.
  6. Weld the edge where the junction plate is loose.
  7. Grind the welds.
  8. Apply primer to all ground surfaces.
  9. Apply anti-corrosion agent after painting. Use Terotex HV 400.
  10. Connect the wiring harness.
  11. Fit the carpet.
  12. Fit the scuff plate.
scientia non olet · About LEMON Manuals