Alternative 3
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
When the light switch is in position 0 or 1, the dipped beams should be on.
In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).
IMPORTANT:
Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives.
The fuse 35 has been removed from cars on markets where daylight driving lights are not used. Program alternatives 1 and 2.
While the engine is being started, the dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but only for max. 20 seconds for safety reasons.
The fuse 35 has been removed from cars on markets where daylight driving lights are not used. Program alternatives 1 and 2.
While the engine is being started, the dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but only for max. 20 seconds for safety reasons.