Rear Brake Pads: Installation
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
- Grease the sliding surfaces on the brake pads with brake grease.
- Install the NEW brake pads in the brake caliper.
- Install the retaining spring and the pins.
- Install the wheel. Tighten lug studs to specification. See TORQUE SPECIFICATIONS .
- Lower the car and depress the brake pedal to press out the brake pistons. Top off with DOT 4 brake fluid as necessary.