LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Brakes - Repair) >> Removal & Installation >> Rear Brake Caliper >> Installation

Rear Brake Caliper: Installation

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper and plate shield, secure the bolts with Loctite 242 (74-96-268). Tighten rear brake caliper bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Connect the brake pipes. Tighten brake pipes to specification. See TORQUE SPECIFICATIONS  .
  3. Install the brake pads, pins and retaining spring.
  4. Remove the brake pedal clamp and bleed the system.
  5. Install the wheels. Tighten lug studs to specification. See TORQUE SPECIFICATIONS  .
  6. Lower the car and depress the brake pedal to press out the brake pistons. Top off with DOT 4 brake fluid as necessary. Install No. 12 fuse.
scientia non olet · About LEMON Manuals