To fit

Plug in the connector.

Fig 1: Illustration For Step 1-2
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Tip the headlamp in and guide the control stud into the hole.
Refit the fixing screws.

Fig 2: Illustration For Step 3
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Raise the casing below the headlamp and guide between the headlamp and holder. Press the casing back so that the casing lugs engage in the holder.

Fig 3: Pressing Casing Back
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Refit the bumper casing screws in the inner wing.

Fig 4: Illustration For Step 5
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Refit the clip to the top radiator bracket.

Fig 5: Illustration For Step 6
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Refit the spoiler shield. Plug in the connector and refit the contact piece. Refit the washer hose where applicable.

Fig 6: Illustration For Step 7
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Check the bumper fit and headlamp setting.