To fit
- Clean the anti-roll bar and grease the inside of the bushes with 30 20 476 Ball bearing grease. Fit the bushes to the anti-roll bar and fit the caps.
- Fit the anti-roll bar to the subframe.
Tightening torque bolt 8-8 (flange diameter 15.2 mm): 18 Nm (13 lbf ft) and use THREAD LOCKING ADHESIVE .
Tightening torque bolt 10-9 (flange diameter 16.7 mm): 31 nm (23 lbf ft)
- Fit the anti-roll bar link to the steering swivel member on both sides. See Figure
.
Tightening torque 53 Nm (39 lbf ft)
- Lower the car to the floor.