To fit
- Press the spring link down and position the coil spring with spring support on it.IMPORTANT: The marking on the coil spring should face rearwards.
- Place a jack under the spring link.
- Raise the spring link and screw in the retaining bolt for the lower damper mounting. Tighten the bolt, using a torque wrench.
Tightening torque 62 N.m (46 lbf ft)
- Remove the jack and fit the wheel.
- Fit the wheel. See WHEEL & TIRES
.
Tightening torque: 110 N.m (81 lbf ft)
Lower the car to the floor.