Starter motor cranking
WARNING: This page is about a different car, the 2003 Saab 9-3 and 2002 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
As soon as the control module localizes the large hole in the armature, injection will be based on crankshaft angle.
The fuel quantity is still regulated by engine coolant temperature only and is decreased gradually as starter motor cranking continues.
Injection is interrupted if the accelerator is depressed fully. This makes it possible to rectify a flooded engine.
The engine is considered to have started as soon as the engine speed exceeds 650 RPM and the fuel quantity is then calculated using the mass air flow sensor as the main sensor.