LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2001 >> 9-3 Base, 4D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (TRIONIC T7 Fuel Control System) >> Fault Diagnosis, General >> Enhanced ignition discharge module for Trionic 7 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2003 Saab 9-3 and 2002 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a value is already displayed for "Failure Status" before the engine is started 

    Note "Failure Status" and "IDM Check Code". Remedy in accordance with the table above. If the car is under warranty, state "IDM Check Code" on the warranty report.

  2. If no value is displayed for "Failure Status" before the engine is started 

    Run the diagnosis in accordance with the instructions in the "Information Text" field on the Tech2 screen. If a value for "Failure Status" is displayed during starter motor cranking, during the synchronization phase or after the ignition key has been released back to ON after an attempt at starting, note "Failure Status" and "IDM Check Code".

    Remedy in accordance with the table above. If the car is under warranty, state "IDM Check Code" on the warranty report.

scientia non olet · About LEMON Manuals