Procedure 2

Fit spacer, part no. 69 92 028.

1. Maneuver the soft top so that the soft top cover is open.
2. Remove the spacer adhesive. Grind the opposite side.
3. Grind the adhesion surface of the swivelling covers on the soft top cover.
4. Apply Loctite 406 on the ground side of the spacer. Fit the spacer as shown in the illustration.
   Fig 1: Fitting Spacer

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
5. Check that the noise no longer occurs.