LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2001 >> 9-3 Base, 4D Hatchback, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Mirrors >> Glass, Windows And Mirrors >> Adjustment - Replacement >> Adjusting the front side window interior moulding, 3D, CV >> Adjustment

Adjusting the front side window interior moulding, 3D, CV: Adjustment

  1. Push down the moulding to the correction position. Remove the door panel.
  2. Lower the side window.
    IMPORTANT: Protect the side window when drilling by placing a putty knife or similar tool between the interior side window moulding and the side window.
  3. Drill a 2 mm hole about 10 mm (3D) or about 55 mm (CV) from the rear of the interior window moulding.

    Drill through the moulding and the metal flange.

    4. Fig 1: Drilling 2 mm hole 10 mm (3D) or 55 mm (CV) From Rear Of Interior Window Moulding
    G03509455Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Screw on the moulding.
  5. Fit the door trim. See ADJUSTMENT - REPLACEMENT in INTERIOR EQUIPMENT.
scientia non olet · About LEMON Manuals