LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2001 >> 9-3 Base, 4D Hatchback, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Equipment >> Adjustment - Replacement >> Cup holder >> To Fit

To Fit

  1. Press in the cartridge with cup holder. Press out the hooks with a small screwdriver.
  2. Plug the connector into the SID unit.
  3. Slide the SID unit into its holder. Take care not to jam the cable.
    Fig 1: Sliding SID Unit Into Holder
    G03509985Courtesy of SAAB-SCANIA OF AMERICA, INC.
    IMPORTANT: Make sure the lock tabs on the main unit have not been pressed in too far, as this will prevent the unit fastening securely in the dashboard.
  4. Plug in the connector and the antenna cable to the main unit.
    Fig 2: Installing Connector And Antenna Cable To Main Unit
    G03509986Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Plug in the DIN connector for the external amplifier if the car is fitted with one.
  6. Slide the main unit into the console until a click is heard.
  7. Check that the cup holder is functioning satisfactorily.
  8. Check the operation of the audio unit and set the time on the clock.
scientia non olet · About LEMON Manuals