LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1992 >> 900 Base, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [L], 2.1L 4-CYL [E], 2.3L 4-CYL [B,M] >> Removal & Installation >> Oil Pan >> Removal

Oil Pan: Removal

  1. Remove dipstick. Stuff rag into opening. Raise and support front of vehicle. Drain engine oil. Remove right front wheel and inner fender panel. Remove front and rear engine mount nuts, O2 sensor, and front section of exhaust pipe. Remove torque strut through-bolt. Lift engine slightly. Remove lower oil pan-to-transaxle bolt.
  2. Disconnect wiring from oil level sensor. Remove turbocharger brace and oil return line (if equipped). Fold down splash plate. Remove rubber plugs from transaxle housing to gain access to rear oil pan bolts. Remove oil pan retaining bolts. Tap guide sleeve into engine block. Remove oil pan. Remove guide sleeve.
scientia non olet · About LEMON Manuals