LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1992 >> 900 Base, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [L], 2.1L 4-CYL [E], 2.3L 4-CYL [B,M] >> Removal & Installation >> Cylinder Head >> Removal (9000 Series)

Removal (9000 Series)

  1. Remove turbocharger (if equipped) and exhaust manifold as an assembly. See EXHAUST MANIFOLD . Disconnect lead from temperature sender. Remove intake manifold. See INTAKE MANIFOLD . Remove engine mount bolts from cylinder head.
  2. Disconnect hoses from valve cover. Remove ignition cartridge and valve cover. Rotate crankshaft to align "0" mark on flywheel with timing mark on flywheel cover. Remove camshaft sprockets and chain tensioner. Remove 2 timing cover-to-cylinder head bolts.
  3. Detach starter lead from clip on thermostat housing. Remove cylinder head bolts. Install guide pin into top right corner of cylinder head. Ensure timing chain is positioned so that pivoting chain guide does not obstruct cylinder head. Lift cylinder head from engine.
scientia non olet · About LEMON Manuals