LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1992 >> 900 Base, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [L], 2.1L 4-CYL [E], 2.3L 4-CYL [B,M] >> Removal & Installation >> Cylinder Head >> Removal (900 Series)

Removal (900 Series)

  1. Remove intake manifold. See INTAKE MANIFOLD . Remove turbocharger (if equipped) and exhaust manifold. See EXHAUST MANIFOLD . Remove 2 timing cover-to-cylinder head bolts. Remove engine mount bolts from cylinder head.
  2. Disconnect lead from temperature sender. Remove inspection panel from valve cover. Remove distributor cap and spark plug leads as an assembly. Remove valve cover. Disconnect crankcase ventilation hose. Remove split rubber plugs from cylinder head.
  3. Align timing mark on flywheel with "0" mark on flywheel cover. Remove camshaft chain tensioner, camshaft chain and sprockets. Raise engine to permit removal of cylinder head from engine brace. Remove cylinder head bolts in reverse order of tightening sequence. See Fig 1.
Fig 1: Cylinder Head Bolt Tightening Sequence
G82162Courtesy of SAAB-SCANIA OF AMERICA, INC.
scientia non olet · About LEMON Manuals