LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1992 >> 900 Base, 4D Sedan, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [L], 2.1L 4-CYL [E], 2.3L 4-CYL [B,M] >> Overhaul >> Cylinder Block Assembly >> Piston & Rod Assembly

Piston & Rod Assembly

  1. Mark pistons for reassembly reference. Rod and cap for each cylinder are stamped with an identification number (1-4). Piston pins are retained by circlips. Remove circlips and press out piston pins. Check pins and bearings for wear or damage and replace as necessary.
  2. Install piston and rod assembly with number on rod and cap facing exhaust side of engine. Install piston with notch on top of piston (at outer circumference) facing timing chain end of engine.
scientia non olet · About LEMON Manuals