Rear Axle Hubs, Bearings & Seals

1. Raise rear of vehicle and support at frame.
2. Remove wheel, caliper and disc.
3. Remove dust cap, locking device nut and washer.
4. Remove hub assembly, using a suitable puller if needed. Hub, bearing, and seals are an integral unit and must be serviced as an assembly.
5. Reverse procedure to assemble.
6. Torque hub nut to 300 nm (220 ft lbs).
7. Stake the locking ring to the spindle.
8. Install Wheels. torque lug nuts to 90 nm (72 ft lbs).