LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1982 >> 900 S, 2D Hatchback, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 900 & 900 Turbo 4-Cylinder >> Engine, Manifolds & Cylinder Head >> Engine >> Installation

Engine, Manifolds & Cylinder Head: Engine: Installation

  1. Ensure that universal joints are packed with grease. Fit new gaskets to the exhaust pipe flanges. Suspend engine and balance it so the front engine mount will locate in its bracket before the rear.
  2. Lower the assembly, guiding the front mount into its bracket and continue to lower engine until rear of engine is 2" (50-60 mm) above mountings.
  3. Move the engine to the right and guide in the left universal joint. Lower the engine carefully, guiding it into the mountings, and at the same time aligning the right universal joint. Ensure that exhaust pipe flanges line up.
  4. Refit the right end piece to the control arm. Tighten universal joints and install rear engine mounting bolts. Tighten all engine mountings. To complete installation, reverse removal procedures.
scientia non olet · About LEMON Manuals