Mounting Automatic Transmission

1. Replace two O-rings -1-  on the electric motor and grease the shaft splines -2-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   O-rings and splines on electric motor

2. Mount automatic transmission.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Automatic transmission with workshop crane and round slings

   1. 2.1 Position automatic transmission -1-  above the electric motor using > 3033 - lifting tackle  and a workshop crane -3-  .
   2. 2.2 Carefully lower the automatic transmission -1-  . A second person must guide the automatic transmission in order to prevent it from tilting.
3. Fit screws in the sequence -1 to 8-  and tighten them.

   > Initial tightening 50 Nm (37 ftlb.) 

   > Torque angle 60 ° 

   Fig 1: Automatic Transmission Flange Screws Tightening Sequence

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Tightening sequence for flange screws for automatic transmission

4. Fit and tighten two screws -2-  .

> Tightening torque 30 Nm (22 ftlb.) 

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws for power electronics