Replacing Stone Guard Film

Heat stone guard film -1- using > V.A.G 1416 - hot-air blower and pull it off.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Stone guard film
Remove adhesive residues using cleaning agent.
Information
- Bonding surfaces must be free of silicone, grease and oil residues.
Clean the paint surface with isopropanol and rub it dry using a lint-free, moisture-absorbing cloth.
Coat bonding area with application fluid.
Information

Only pull off thin protective film after bonding.

Information
- Affix stone guard film immediately after spraying.
Pull off backing sheet and coat the bonding area of the stone guard film with application fluid.
Taycan Saloon: Affix stone guard film -1- along the front edge of the rear wheel arch -2- with gap dimension -LHD vehicle - and press it on lightly. Adjust the position slightly if necessary. > Distance 3 mm +/- 1 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Affixing stone guard film
Taycan Cross Turismo: Place stone guard film -1- along the wheel cover on the door -2- with a gap dimension of -LHD vehicle - and press it on lightly. Adjust the position slightly if necessary. > Distance 3 mm +/- 1 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Affixing stone guard film

Information

Adhesive is activated by contact pressure. The contact pressure must be at least 2 kg.
Press on stone guard film from the inside out using a plastic squeegee to squeeze out water and bubbles.
Pull off thin protective film.
Dry off the entire area using a lint-free, moisture-absorbing, non-scratching cloth.
Check affixed stone guard film.
1. 11.1 Check that there are no bubbles.
2. 11.2 Check that the corners are affixed correctly.
3. 11.3 Press them on again if necessary.