Installing Closing Element

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Install closing element and check that it fits perfectly.
2. Apply adhesive on the joint area of the body.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Working with body structural adhesive

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Apply adhesive

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Apply adhesive

3. Apply adhesive to the closing element.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Apply adhesive

   1. 3.1 Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm 
4. Rivet in closing element. > BLIND RIVETS 999.190.227.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Riveting in closing element