Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screws on protective plate for supply line section on underbody | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw on line bracket for supply line section on underbody | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw on line bracket for supply line section in engine compartment | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw on line bracket for supply line section at high-pressure pump | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Nuts securing line bracket for supply line section at high-pressure pump | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Union nut for fuel line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | tightening torque of | 10 Nm (7.4 ftlb.) |