Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Tie-rod ball to wheel carrier cone | M12 x 1.5 thread/always use new nuts following removal | Tightening torque | 100 Nm (74 ftlb.) | ||
| Lower trailing arm to wheel bearing housing | M14 thread/always replace nuts following removal | Tightening torque | 140 Nm (104 ftlb.) | ||
| Lower trailing arm to frontaxle carrier | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 70 Nm | ||
| Lower trailing arm to frontaxle carrier | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 180° | ||
| Level sensor to lower trailing arm | M6 thread | Tightening torque | 9 Nm | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 90 Nm (67 ftlb.) | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° |