LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2024 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (10 Engine - Crankcase, Suspension 3.0L -- 95B - MACAN (95B)) >> WM, 100119 Removing And Installing Engine (V6 Turbo) >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery.
    • 270619 Removing and installing vehicle electrical system battery 
  2. Move bonnet into service position.
    • 552213 Securing front lid (service position) 
  3. Remove engine cover (design cover).
    • 108319 Removing and installing engine cover (design cover) 
  4. Remove air cleaner housing.
    • 242519 Removing and installing air cleaner housing (V6 Turbo) 
  5. Remove torque support.
    • 103719 Removing and installing torque support (V6 Turbo) 
  6. Disconnect pressure hose at the throttle housing.
    • 244219 Removing and installing throttle housing 
  7. Remove DME control unit.
    • 247019 Removing and installing DME control unit 
  8. Remove front strut.
    • 408619 Removing and installing front strut 
  9. Remove cowl panel cover.
    • 508719 Removing and installing cowl panel cover 
  10. Remove filler neck from the washer-fluid reservoir.
    • 926019 Removing and installing windscreen-washer reservoir 
  11. Remove front wheels.
    • 440519 Removing and installing wheel 
  12. Remove front wheel housing liners.
    • 505619 Removing and installing front wheel housing liner 
  13. Loosen front brake callipers and hang them at a suitable position.
    • 473909 Loosening and securing front brake calliper 
  14. Only for vehicles with PCCB brakes: 

    Remove front PCCB brake discs.

    • 465119 Removing and installing front PCCB brake disc 
  15. Drain coolant.
    • 193817 Draining and filling coolant (V6 Turbo) 
  16. Remove rear cardan shaft.
    • 393519 Removing and installing rear cardan shaft 
  17. Remove front underbody cover.
    • 519219 Removing and installing cover for front underbody 
  18. Disconnect pressure hose on charge-air cooler.
    • 214319 Removing and installing charge-air cooler 
  19. Remove air-conditioning compressor.
    • 873419 Removing and installing air-conditioning compressor 
  20. Disconnect ATF cooling line at the connection point.
    • 386219 Removing and installing line for ATF cooling (V6 Turbo) 
  21. Loosen locking cable on transmission side.
    • 371319 Removing and installing locking cable 
  22. Only if the double clutch transmission must be removed: 

    Remove power-steering gear.

    • 489019 Removing and installing power-steering gear 
scientia non olet · About LEMON Manuals