LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2024 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (42 Rear Wheel Suspension Drive Shaft 3.0L -- 95B - MACAN (95B)) >> WM, 423555 Replacing Upper Control Arm >> Replacing Upper Control Arm >> Removing Upper Control Arm

Removing Upper Control Arm

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen upper control arm -1-  on rear axle housing.
    G15154913Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Upper control arm on rear axle housing

    1. 1.1 Unscrew screw securing upper control arm to rear axle housing -2-  and counter at nut -3-  at the same time.
  2. Remove upper control arm -1-  .
    G15154914Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Upper control arm on wheel bearing housing

    1. 2.1 Release and disconnect electric plug connection for brake pad wear indicator -2-  .
    2. 2.2 Mark position of the eccentric adjuster -3-  for re-installation.
    3. 2.3 Unscrew screw on upper control arm -4-  and counter at nut -5-  at the same time.
    4. 2.4 Remove upper control arm -1-  .
scientia non olet · About LEMON Manuals