Pressure Pipe And Intake Pipe (V6 Monoturbo)
WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
Overview of pressure pipe and intake pipe (V6 monoturbo)
| 1 | Upper pressure pipe (from charge-air cooler to charge-air cooler) |
| 2 | Lower pressure pipe (from charge-air cooler to charge-air cooler) |
| 3 | Side pressure pipe (from turbocharger to charge-air cooler) |
| 4 | Intake pipe |
| 5 | Screws securing intake pipe to turbocharger |
| 6 | Screws securing side pressure pipe to turbocharger |
| 7 | > Tightening - torque 8 Nm (6 ftlb.) |
| 8 | Sealing ring on intake pipe |
| 9 | Sealing ring on side pressure pipe |
| 10 | > Tightening - torque 4 Nm (3 ftlb.) |
| 11 | Screw-type clamp on upper pressure pipe > Tightening - torque 5.5 Nm (4 ftlb.) |
| 12 | > Tightening - torque 5.5 Nm (4 ftlb.) |
| 13 | Screw securing side pressure pipe to intake-air distributor |
| 14 | Screws securing side pressure pipe - upper part to lower part |
Overview of charge-air cooler (V6 biturbo)
| 1 | Boost pressure sensors |
| 2 | Screws securing boost pressure sensors to charge-air cooler |
| 3 | Screw-type clamps |
| 4 | Screws for charge-air cooler |
| 5 | Screw-type clamps |
| 6 | Screw-type clamps > Tightening - torque 5.5 Nm (4 ftlb.) |