Installing Starter (V6 Turbo)

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:

Tighten new screw -5- .
- Tightening torque 65 Nm (48 ftlb.)
Tighten new screw -4- .
- Initial tightening 30 Nm (22 ftlb.)
- Final tightening + 105°
Tighten nut -2- .
- Tightening torque 23 Nm (17 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Starter
Install line for ATF cooling at the top with new O-rings.
1. 4.1 Screw in and tighten screw -3- .
  - Tightening torque 20 Nm (15 ftlb.)
2. 4.2 Screw in and tighten screw -2- .
- Tightening torque 8 Nm (6 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF cooling line, top
Screw in and tighten screws -2- .
- Tightening torque 8 Nm (6 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF cooling line, bottom
Tighten screws -2- on engine support.
- Tightening torque 50 Nm (37 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Right engine support
Tighten nut -2- .
- Tightening torque 20 Nm (15 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric line from starter to engine support