Adjust Rear-Axle Camber

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Adjust camber at the rear axle -1- at the upper control arm.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Camber adjustment on rear axle
1. 1.1 Loosen nut -3- on threaded joint for the upper control arm -1- at the wheel side.
2. 1.2 Turn the camber eccentric on the hexagon -2- of the eccentric screw until the camber value of the wheel is in the target range.
3. 1.3 Tighten the nut -3- and counter at the hexagon -2- .
  > Tightening - torque 95 Nm (70 ftlb.)
4. 1.4 Check the camber value again.