Installing Supply Line - Section At High-Pressure Pump

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:

1.1 Tighten nuts -9- .

Tightening torque 9 Nm (6.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Supply line on high-pressure pump

1.2 Tighten screw on line bracket -6- .

Tightening torque 9 Nm (6.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Supply line on high-pressure pump

1.3 Tighten union nut -4- and counter at the hexagon -5- at the same time.

Tightening torque of 10 Nm (7.4 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Supply line on high-pressure pump

1.4 Tighten screw on holder -3- .
- Tightening torque 9 Nm (6.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuel line on holder