Mounting Specifications For Charge-Air Cooler And Pressure Hoses - V6 Monoturbo

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

To prevent vibrations and noises, the mounting specifications must always be observed.

Fig 1: Charge - Air Cooler And Pressure Hoses Component Locations - V6 Monoturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting specifications for charge-air cooler and pressure hoses - V6 monoturbo

A	Distance from sleeve on bearing to rubber sleeve at least 3.0 mm

Arrows Markings on the pressure hoses and charge-air cooler/throttle valve

Markings on the pressure hose must be aligned with the groove on the throttle valve and on the charge-air cooler.
Marking on the pressure hose must be aligned with the groove on the charge-air cooler.
The centre point of the screw head must be centered in the bearing (deviation permitted only in the centre of the vehicle)
Marking on the pressure hose must be aligned with the groove on the charge-air cooler.
Sleeve on the bearing must protrude forward from the rubber sleeve in idle state.
Sleeve on the bearing must protrude forward from the rubber sleeve in idle state.
Marking on the pressure hose must be aligned with the groove on the charge-air cooler.
Marking on the pressure hose must be aligned with the groove on the charge-air cooler.

Component overview of charge-air cooler at the left and right (only valid for V6 monoturbo):

Fig 2: Charge - Air Cooler Component Locations - V6 Monoturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Component overview of charge-air cooler - V6 monoturbo

Tightening sequence for charge-air cooler:

Fig 3: Charge - Air Cooler Screws Tightening Sequence (Shown On Left Charge - Air Cooler)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence for charge-air cooler (shown on left charge-air cooler)

Installation is performed in reverse order. Pay particular attention to the following:

1.1 Replace O-rings.
1.2 Check seal on intake manifold for damage and replace it if necessary.

1.3 Tighten screws on intake manifold -5- .

Tightening torque 8 Nm (6 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Intake manifold