Removing Front-Axle Support

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information

Risk of damage to chassis components

If the front-axle carrier, steering gear or front-axle support is not fitted correctly, never lower the vehicle onto its wheels!
Supporting the vehicle on the front-axle carrier or on the front-axle support (e.g. using a jack) is not permitted!
If the vehicle needs to be moved, the front-axle support must be installed beforehand using the old bolts and square nuts and must then be tightened to the specified torque without additional torque angle.

Remove heat insulation -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat insulation
1. 1.1 Unclip clips -2- .
2. 1.2 Unscrew screws on heat insulation -3- .
3. 1.3 Guide out and remove heat insulation -1- .
Remove front-axle support -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front-axle support
1. 2.1 Disconnect electric line -2- at the positions -3- from front-axle carrier -1- .
2. 2.2 Unscrew screws -4 and 5- and remove front-axle support -1- .