Subsequent Work

WARNING: This page is about a different car, the 2021 Porsche Macan, 2020 Porsche Macan, and 2019 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Install new crankshaft sealing ring (flywheel side).
> 135955 - REPLACING CRANKSHAFT SEALING RING - FLYWHEEL SIDE (V6 TURBO)
Install flywheel.
> 136019 - Removing and installing flywheel (V6 turbo) , Refer to the appropriate service information
Install pulse sender.
> 287319 - REMOVING AND INSTALLING PULSE SENDER (V6 TURBO)
Install upper chain housing cover.
> 153319 - REMOVING AND INSTALLING UPPER CHAIN HOUSING COVER (V6 TURBO)

Only after removing upper chain housing cover on right cylinder bank:

Install additional coolant pump holder -1- .

1.1 Position additional coolant pump holder -1- , fit double screw securing holder to chain housing cover -3- and tighten it.
> Tightening - torque 9 Nm (6.5 ftlb.)

1.2 Fit and tighten screws securing additional coolant pump to holder -2- .

> Tightening - torque 1.5 Nm (1 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Additional coolant pump (right cylinder bank)

For engine with particle filter
Install particle filter.

> 267419 - REMOVING AND INSTALLING PARTICLE FILTER
For engine without particle filter
Install catalytic converter.

> 267319 - REMOVING AND INSTALLING CATALYTIC CONVERTER
Install the engine.
> 100119 - REMOVING AND INSTALLING ENGINE
Fill up coolant.
> 193817 - DRAINING AND FILLING COOLANT