LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> 43 Leveling System, Air Suspension, Damper Control 2.0L -- Y1A - TAYCAN (Y1A) >> WM, 433419 Removing And Installing Sensor For Body (Front, On Wheel Side) >> Removing Sensor For Body

Removing Sensor For Body

NOTE: Voltage peaks 
  • Risk of damage to electrical load or to the control unit 

    → Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).

    → Switch off electrical loads before disconnecting or removing them.

Information 

The procedure for removing and installing is described for one side as an example. The procedure for the other side is almost identical.

  1. Remove sensor for body -1-  .
    1. 1.1 Release and disconnect electric plug connection -2-  .
    2. 1.2 Unscrew screw -3-  .
    3. 1.3 Remove sensor for body -1-  from holder -4-  .
    G15553202Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front sensor for body on wheel side

scientia non olet · About LEMON Manuals