LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (26 Exhaust System 4.0L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 261219 Removing And Installing Upper Centre Catalytic Converter Heat Shield (V8 BITURBO) >> Installing Upper Centre Catalytic Converter Heat Shield

Installing Upper Centre Catalytic Converter Heat Shield

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Components not fitted when engine is running or during test drive 
  • Risk of damage to components due to reduced cooling performance 

    → Before starting the engine, make sure that all air-supply components are completely fitted.

    → Only start the engine when the heat shields and design cover are fitted.

    → Only test drive the vehicle when all underbody panelling, heat shields and the design cover are fitted.

NOTE: Heat shields not fitted correctly 
  • Risk of damage to components due to over-heating 

    → Check that the heat shields are screwed on fully.

    → Check that the heat shields overlap fully and without gaps.

    → Do not put pressure (body weight, tools) on heat shields.

    → Store removed components in a safe place.

    → Replace damaged or deformed heat shields and safety clips.

  1. Install upper centre catalytic converter heat shield -1-  .
    1. 1.1 Carefully guide in upper centre catalytic converter heat shield -1-  .
    2. 1.2 Fit and tighten screws -2-  .

      > Tightening torque 9 Nm (6.6 ftlb.) 

      G15879559Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Upper centre catalytic converter heat shield (Thermamax)