Removing Lower Chain Housing Cover (V6 Turbo)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew screw on coolant line holder -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower chain housing cover
Unscrew upper screws chain housing cover lower -1- on both cylinder banks.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Upper screws on lower chain housing cover
Remove lower chain housing cover -3- .
1. 3.1 Unscrew the screws of the chain housing cover at the bottom -1- .
2. 3.2 Screw one screw into each of the threaded bores -Arrows- by hand.
3. 3.3 Tighten the screws carefully and evenly to release the chain housing cover from the bonding at the bottom -3- .
4. 3.4 Remove the chain housing cover at the bottom -3- .
5. 3.5 Unscrew the screws used for loosening from the lower chain housing cover -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower chain housing cover
Clean sealing faces.
Remove and replace crankshaft sealing ring.
> Refer to 135919 Removing and installing crankshaft sealing ring (flywheel side) (V6 Turbo) in the appropriate service information.