Subsequent Work
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Remove all staking tools.
- Fit stoppers on camshafts -1-
.
- 2.1 Insert stoppers on camshafts -1- .
- 2.2 Fit screws for stoppers -1- and tighten to > Tightening torque 9 Nm (6.5 ftlb.) .
Stoppers on camshafts.
- Fit screw plug in bore for crankshaft locking pin and tighten it.
Old variant with O-ring - replace O-ring : > Tightening torque 25 Nm (18.4 ftlb.)
New variant with micro-encapsulation - Use new screw plug : > Tightening torque 40 Nm (29.5 ftlb.)
- Only for V6 monoturbo:
Install intake distributor centre.
> Refer to Removing and installing centre intake-air distributor (V6 monoturbo) in the appropriate service information.
- Install brake booster vacuum pump.
- Install upper chain housing cover.
> in the appropriate service information.Removing and installing upper chain housing cover (V6 Turbo) in the appropriate service information.