Removing Front Brake CALLIPER

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal of brake calliper

Paint defects on brake calliper
→ Proceed with care when setting back the brake pads.

→ Protect the paintwork on the brake calliper from damage using a suitable cloth.

Information

The core of the warning contact line must not be left exposed! Worn insulation will result in malfunctions.
If necessary, remove a little brake fluid from the reservoir by suction in order to prevent an overflow when the disc brake pads are pushed back!

Information

For easier access, turn the steering fully to the left or right!

Release and disconnect electric plug connection for brake pad wear indicator -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection for brake pad wear indicator
Unscrew screws -4- and loosen brake line holder -5- from the wheel bearing housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening brake line holder
Press the brake pedal and clamp it using a pedal support.
Loosen union nut -1- and remove brake line -2- from the brake calliper. Collect brake fluid in a suitable container.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake line mounting on brake calliper

Information

Use >T10439 - assembly pins > Assembly pin for brake calliper Assembly pin for brake calliper to make it easier to remove/install the brake calliper.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Assembly pin for brake calliper

Information
- Do not use an impact bolter.
Unscrew screws -1- and remove front brake calliper -2- from the wheel bearing housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for front brake calliper