LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (19 - Engine - Cooling 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 194519 Removing And Installing Additional Coolant Pump For Low-Temperature System (P1, P2) (Hybrid) >> Installing Additional Coolant Pump For Low-Temperature System >> Installing Additional Coolant Pump For Low-Temperature System (P2)

Installing Additional Coolant Pump For Low-Temperature System (P2)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install additional coolant pump for low-temperature system -1-  .
    1. 1.1 Insert additional coolant pump for low-temperature system -1-  into holder -6-  .
    2. 1.2 Close holder -6-  and fit and tighten screw -5-  .

      > Tightening torque 8 Nm (6 ftlb.) 

    3. 1.3 Connect and lock cable plug -4-  .
    4. 1.4 Push on coolant hoses -3-  and tighten spring band clamps -2-  using > VAS 6890 - Spring Band Clamp Pliers  .
      G15823250Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Additional coolant pump for low-temperature system (P2)

  2. Secure holder -1-  .
    1. 2.1 Move holder -1-  into installation position.
    2. 2.2 Screw on nut -2-  and screw in screws -3-  .
    3. 2.3 Tighten screws -3-  .

      > Tightening torque 8 Nm (6 ftlb.) 

    4. 2.4 Tighten nut -2-  .

      > Tightening torque 6 Nm (4.5 ftlb.) 

      G15823251Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Bracket

scientia non olet · About LEMON Manuals