LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (26 Exhaust System 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 260119 Removing And Installing Exhaust System >> Installing Exhaust System

Installing Exhaust System

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installing exhaust system
    1. 1.1 Position exhaust system on a transmission jack and secure it with a tension strap -arrows-  .
      G15878124Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Securing exhaust system on transmission jack (similar to illustration)

  2. Fit and tighten screws -1-  on the rear silencer holders -2-  .

    > Tightening torque 23 (1 7 ftlb.) Nm 

    G15878125Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rear silencer holders (figure shows V8 Turbo)

  3. Loosen secured decoupling elements -1-  .
    G15878126Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening decoupling elements

  4. Fit exhaust system on transmission support.
    1. 4.1 Fit and tighten screws -4-  on transmission support holders -3-  .

      > Tightening torque 23 Nm (17 ftlb.) 

    2. 4.2 Attach new ball clamps -2-  to the connection between the catalytic converters and front silencer.
      1. 4.2.1 Tighten ball clamps -2-  .

        > Tightening torque 35 Nm (26 ftlb.) 

        G15878127Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Exhaust system on transmission support

  5. Fit holder for centre exhaust system mount -2-  .
    1. 5.1 Fit and tighten screws -1-  .

      > Tightening torque 23 Nm (17 ftlb.) 

      G15878128Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Centre exhaust system mount

  6. For vehicles with sports exhaust system:  Connect vacuum hose -1-  to vacuum unit for exhaust flap -2-  .
    G15878129Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Vacuum hose for exhaust system

  7. Plug in cable plugs -1-  on actuators -2-  .
    G15878130Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Actuator for exhaust flap

  8. For vehicles with rear axle steering:  Fit strut -4-  between the rear silencers.

    > Tightening torque 23 Nm (17 ftlb.) 

    G15878131Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Exhaust system (figure shows V8 Turbo)

  9. Install tunnel stut -3-  .
    1. 9.1 Fit and tighten screws -1 and 2-  .

      > Tightening torque 50 Nm (37 ftlb.) 

      G15878132Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Tunnel strut