Installing Fuel Line (High-Pressure, Left)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

Check fuel line for damage following removal and replace it if necessary.

Coat thread on union nuts with Microgleit DF 977S. Observe a drying time of at least 5 minutes before fitting.
Guide in fuel line and fit union nut -1- on high-pressure fuel line at the right by hand.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing on union nut on high-pressure fuel line at the right
Press sound absorber aside and fit union nut -1- on the left rail by hand.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing on union nut on left rail
Screw in and tighten screws -1- .
> tightening torque 8 Nm (5.9 ftlb.)

> final tightening torque 45°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing in screws
Tighten union nuts using > T40055 - socket-wrench insert .
> tightening torque of 10 Nm (7.4 ftlb.)

> Torque angle 60°
Fit brake booster vacuum line -2- and connect line connection -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake booster vacuum line

Secure additional coolant pump coolant pipe -1- .

7.1 Position additional coolant pump -1- .
7.2 Fasten spring band clamp -3- using > VAS 6890 - spring band clamp pliers .

7.3 Screw in and tighten screws -2 and 4- .

> Tightening torque 9 Nm (6.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Additional coolant pump coolant pipe