LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (24 Fuel System - Electronic Injection 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 247019 Removing And Installing DME Control Unit >> Removing DME Control Unit

Removing DME Control Unit

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Voltage peaks 
  • Risk of damage to electrical load or to the control unit 

    → Remove the ignition key and switch off load before disconnecting or removing load.

  1. Remove retaining clip -2-  from DME control unit holder.
    G15878076Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing line clip

  2. Remove cable holder for electric wire harness -3-  and unclip wire harness from DME control unit holder -arrows-  .
    G15878077Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping electric wire harness

  3. Unscrew screws -4-  and guide holder -5-  with DME control unit -1-  out of the bracket.
    IMPORTANT: Danger of injury from sharp edges on holder.
    G15878078Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unscrewing screws

  4. Release and disconnect electric plug connections -6-  on the DME control unit -1-  .
    G15878079Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Releasing and pulling off electric plug connections

  5. Unscrew screws -7-  and remove DME control unit -1-  from the holder -5-  .
    G15878080Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing DME control unit

scientia non olet · About LEMON Manuals