LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (24 Fuel System - Electronic Injection 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 246919 Removing And Installing Oxygen Sensor Upstream Of Catalytic Converter (V6 BITURBO) >> Installing Oxygen Sensor Downstream Of Catalytic Converter >> Installing Oxygen Sensor Upstream Of Catalytic Converter On Cylinder Bank 2

Installing Oxygen Sensor Upstream Of Catalytic Converter On Cylinder Bank 2

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install oxygen sensor -1-  upstream of catalytic converter on cylinder bank 2.
    1. 1.1 Grease thread of oxygen sensor -1-  with hot screw paste before installation.
      1. 1.1.1 Make sure that the paste does not get into the slits in the sensor body.
    2. 1.2 Carefully screw in and tighten oxygen sensor -1-  .

      > Tightening torque 52 Nm (38 ftlb.) 

    3. 1.3 Route line -2-  .
      1. 1.3.1 Route the line -2-  and clip it into the cable duct -3-  .
    4. 1.4 Connect electric plug connection -4-  in the engine compartment.
      G15878073Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Oxygen sensor upstream of catalytic converter, cylinder bank 2

scientia non olet · About LEMON Manuals