LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (24 Fuel System - Electronic Injection 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 244219 Removing And Installing Right Throttle Housing >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information 

If the throttle housing was replaced  , it must be taught.

> 9900 - PIWIS Tester 3  must be connected. Then teach the throttle housing.

Select "DME" control unit.

Select "Maintenance and repairs".

Select "Adaptations".

Select "Throttle valve" and start the procedure.

  1. Secure the right strut.

    > 408619 REMOVING AND INSTALLING STRUT (DOME STRUT)

  2. Install front-axle support (front section).

    > 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT

  3. Install cover for front underbody.

    > WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY

  4. Install front trim panel (engine compartment) at the right.

    > WM, 700219 REMOVING AND REINSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) - Coupe or WM, 700219 REMOVING AND REINSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) - Wagon

  5. Install cover for front lock support.

    > WM, 703919 REMOVING AND INSTALLING COVER FOR FRONT LOCK SUPPORT - Coupe or WM, 703919 REMOVING AND INSTALLING COVER FOR FRONT LOCK SUPPORT - Wagon

  6. Install engine cover (design cover).

    > 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER) (V6 TURBO)