Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Observe warning notes.
> 2X00IN GENERAL WARNING NOTES FOR WORKING ON THE HIGH-VOLTAGE VEHICLE ELECTRICAL SYSTEM
Remove engine safety device.
> 1001IN SUPPORTING ENGINE ON THE BODY (ENGINE SAFETY DEVICE)
Install spring struts with front drive shafts
> Refer to the appropriate Service Information for Removing and installing front spring strut

> 433019 REMOVING AND INSTALLING FRONT AIR-SPRING STRUT
Install front-axle support.
> 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT
Install wheel housing liners on both sides of the vehicle.
> WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER
Install front wheels.
> WM, 440519 REMOVING AND FITTING WHEEL
Connect 12-volt battery.
> WM, 270619 REMOVING AND REINSTALLING BATTERY
1. 7.1 Read and follow work instructions after disconnecting the battery.
  > 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
Only for vehicles with PDCC: Start the 48 V system.
> 270703 DISCONNECTING AND STARTING 48 V SYSTEM
Start the high-voltage system and complete the relevant documentation.
> 2X00IN ISOLATING HIGH-VOLTAGE ELECTRICAL SYSTEM FROM POWER SUPPLY/STARTING HIGH-VOLTAGE ELECTRICAL SYSTEM
Bleed the cooling system.
> 193817 DRAINING AND FILLING COOLANT
Perform suspension alignment.
> 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT